ADIC SNC 5100, Scalar 1000 manual FcShowDevs, Ext. Fifo

	SNC 5100
	controller.
Loop ID	The Fibre Channel Loop ID for this interface.
	PtoP indicates a point-to-point connection.
Fabric Attached	Indicates whether the port is attached to a Fabric.
Port Mode	Indicates whether the port is set to Target or
	Initiator mode
Ext. FIFO	Indicates that FIFOs external to the FC controller
	are on the board. If they are, their size in KB will
	be output into this column.
Link Speed	Indicates the actual speed of the connection. This
	figure is only meaningful when the Firmware
	State is reported as Ready.

Caution

If the Firmware State is anything but Ready, the information output by this command will be unreliable.

fcShowDevs

The fcShowDevs command displays information about the devices that are accessible from each Fibre Channel interface. The display shows the LUN that the SNC 5100 has assigned to each device, the SCSI Channel that the device is attached to, the actual SCSI ID and LUN of the device, the vendor, product, revision and serial number of the device.

In the example, Channel Zoning was used for access control. Fibre Channel 1 has access to all of the attached SCSI tape devices. For the other Fibre Channel interface, Channel Zoning has been setup to restrict access to certain devices.

SN60023 > fcShowDevs
FC	1:
LUN		Chan			Id Lun Vendor Product			Rev SN
-----------------------------------------------------
0	0		0	0	ADIC 0338 00000060450d0080
17		3	0 0 OEM			03570C12	5346	000000000305
18		3	0 1 OEM			03570C12	5346	000000000305
19		3	1 0 OEM			03570C12	5346	000000000306
6	1		1	0	OEM OEM DCHS04X		6363	681F775B
7	1		2	0	OEM OEM DCHS04X		6363	682086D3
8	2		3	0	OEM OEM DCHS04X		6363	6820837B
9	2		4	0	OEM OEM DCHS04X		6363	682076AC
FC		2:
LUN		Chan			Id Lun Vendor Product			Rev SN

-----------------------------------------------------

Commands 129

6-00020-02