ADIC SNC 5100, Scalar 1000 manual Saving a Configuration File, Loading a Configuration File

SNC 5100

If HyperTerminal reports an error, try to send the file again.

If the SNC 5100 reports an error, make a note of the error code and see the Table 12, “Zmodem Status Codes,” on page 100 for further information.

Saving a Configuration File

Step 1. From the HyperTerminal window enter sz “config.cfg” <Enter>.

	The filename “config.cfg” is an example of a name. You can
	specify a different filename but it must be in quotes, it must be 8
	characters or less and it must end in .cfg.
Step 2.	From the HyperTerminal window select Transfer and Receive
	File.
Step 3.	From the Receive File dialog enter the path to the folder where
	you want to save the file or click the Browse button and navigate to
	it.
Step 4.	For the Receiving protocol select Zmodem and press the Receive
	button.
Step 5.	Wait for the “Configuration Download Complete” status message to
	be displayed on the service terminal indicating successful
	completion.
	If HyperTerminal reports an error, try to receive the file again.
	If the SNC 5100 reports an error, make a note of the error code and
	see the Table 12, “Zmodem Status Codes,” on page 100 for further
	information.

Loading a Configuration File

Step 1. From the Hyper Terminal window, at the SN60023 > command prompt, type rz and then press the Enter key.

Step 2. From the HyperTerminal window select Transfer and Send File.

Updating Firmware and Configurations 99

6-00020-02