ADIC Scalar 1000, SNC 5100 manual Ethernet Port, Pre-Installation Checklist, on, 138

SNC 5100

Figure 8	Ethernet Port
Step 1.	To configure the network, connect to the SNC 5100 Service Port.
	For more information, see “Connecting to the Service Port” on
	page 95.
	In all of the subsequent steps, substitute the values you determined
	in Step 6 of Table 2, “Pre-Installation Checklist,” on page 19.
Step 2.	Enter the hostNameSet command to set the Host name.
	For more information, see the "hostNameSet" command on page
	138.
	In the example shown, the host name of the SNC 5100 was
	“SN60023” and is now being set to “foster.” The shell prompt will
	change to reflect the new name.

Example:

SN60023 > hostNameSet "foster" Target hostname set to foster value = 0 = 0x0

foster >

Step 3. Use the ethAddrSet command to set the host network address:

For more information, see the "ethAddrSet" command on page 121.

The IP address is specified as four decimal numbers, separated by periods.

Example:

foster > ethAddrSet "192.168.1.54"

Host Address set to 192.168.1.54 for Ethernet interface value = 0 = 0x0

88 Network Setup for the SNC 5100

6-00020-02