ADIC SNC 5100 manual HlthChkLevelGet, HlthChkLevelSet, HlthChkNow, Host add,hostname,ipAddress

SNC 5100

hlthChkLevelGet

To display the current Health Check level, use the hlthChkLevelGet command. The example below shows that the current level is 2.

SN60023 > hlthChkLevelGet value = 2 = 0x02 SN60023 >

hlthChkLevelSet

To set the Health Check level, use the hlthChkLevelSet command. The example below shows setting the level to 3.

SN60023 > hlthChkLevelSet 3 value = 0 = 0x0

SN60023 >

hlthChkNow

The hlthChkNow function causes the SNC 5100 to execute an immediate, level 4 Health Check. Results are displayed that will indicate which devices or subsystems failed the check.

SN60023 > hlthChkNow

Health Check: Starting level 4 check

Health Check: Step 1 -- Checking System

Health Check: Step 2 -- Checking Interfaces

Health Check: Step 3 -- Checking Devices

Health Check: Step 4 -- Checking Device States

Health Check: Passed

value = 0 = 0x0 SN60023 >

host “add”,“hostname”,“ipAddress”

The host “add” command adds the named host to the host table and host file. If the IP address is already assigned to a host, then the new name is added as an alias for the host. The host “add” command is invoked to add known hosts and their IP addresses. Alias names are supported, allowing multiple names to a single host.

The host utilities maintain a host file, nvfs:/mgnt/hosts, which is used

Commands 135

6-00020-02