ADIC Scalar 1000, SNC 5100 manual Ctlr Id

SNC 5100

SN600032 > fcShow
------------------	Fibre Channel Controllers-----------------------
Ctlr : PCI Addr : ISP		:	Firmware	:	Firmware	: Loop :	Fabric	: Port : E
xt. : Link
Id	: Bs Dv Fn : Type	:	State	:	Version	: ID : Attached : Mode : F
IFO : Speed
------------------------------------------------------------------
1	: 00 07 00 : 2300	:	Sync Lost	:	3.00.25	: None :	No	: Targ : N
one : 1 Gbps
2	: 00 08 00 : 2300	:	Sync Lost	:	3.00.25	: None :	No	: Targ : N
one : 2 Gbps

------------------------------------------------------------------------------

value = 95 = 0x5f = ‘_’ SN600032 >

Ctlr Id	Indicates the Port Number for this interface.
PCI Addr	The PCI address of the interface, showing bus,
	device id, and function number.
ISP Type	The type of Fibre Channel Controller.
Firmware State	The current state of the interface as reported by
	the Fibre Channel controller. Firmware states are
	listed below.
Configuration Wait	Firmware is not initialized.
Waiting for AL_PA	Firmware is performing or waiting to perform
	loop initialization.
Waiting for login	Firmware is attempting port and process logins
	with all loop ports.
Ready	Indicates that the interface is connected and
	operational and ready to process SCSI
	commands. Any other value indicates
	intermediate states or interface failure.
Sync Lost	The firmware has detected a loss-of-sync
	condition and is re-synchronizing the serial link
	receiver. This is the state reported when the Fibre
	Channel link does not detect a connection to a
	Fibre Channel device.
Error	The firmware has detected an unrecoverable
	error condition.
Nonparticipating	The firmware is not participating on the loop
	since it did not acquire an AL_PA during
	initialization.
Failed	The firmware is not responding to commands.
Firmware Version	The version of firmware on the Fibre Channel

128 Commands

6-00020-02