ADIC Scalar 1000, SNC 5100 manual Sz filename, Targets

SNC 5100

Device	Index		10
IO Class		Enum	n/a
IO Type Enum			n/a
Label Index			03
Bus Id		1.1.0
--------		SCSI	4 VPD --------
IO Class		Fixed IO
IO Type		SCSI
IO Mfg		LSI Logic
Device	Index		11
IO Class		Enum	n/a
IO Type Enum			n/a
Label Index			03
Bus Id		1.1.1
value =	0	= 0x0
buck172	>

sz “filename”

The sz command initiates a send Zmodem file transfer session. You use this command when you want to save configuration information to a file in case the SNC 5100 needs to be replaced. The SNC 5100 uses Zmodem protocol to upload its persistent address map database and configuration parameter settings from its nonvolatile flash memory to a file on the service terminal. After issuing this command, you start the file transfer from the service terminal by initiating a receive file operation that uses Zmodem protocol.

The filename “config.cfg” is shown in the example below. You can specify a different name for the file but the name must not exceed 8 characters and it must end in .cfg. See also the rz command for information about receiving a configuration file.

SN60023 > sz "config.cfg"

Configuration Download Complete: config.cfg value = 0 = 0x0

SN60023 >

targets

The SNC 5100 maintains a list of target devices that are attached to the I/O channels. The targets command will list each device currently attached, providing descriptions of the devices.

SN60023 > targets

180 Commands

6-00020-02