ADIC Scalar 1000, SNC 5100 manual Event Viewing Default Action, Code Level Threshold

SNC 5100

Table 7: Event Codes and Actions

Event	Viewing	Default		Action2
		Trap	Description
Code	Level1
		Threshold
N.A.	N.A.	N.A.	Persistent reboots	3
N.A.	N.A.	N.A.	Host application error message or host	12
			log entry indicates SCSI target error
N.A.	N.A.	N.A.	Host cannot access attached devices	12
N.A.	N.A.	N.A.	SAN Connection LED off although	2
			cables are attached and host systems
			are on and have booted
N.A.	N.A.	N.A.	Heartbeat failure	7
N.A.	N.A.	N.A.	fcShow command returns	2, 0
			Firmware State = Sync
			Lost
N.A.	N.A.	N.A.	ADIC Management Console failure	7
N.A.	N.A.	N.A.	Service terminal connection failure	8
			Generic Event Descriptions
8	2	0	Sense data recorded following a check	0
			condition
			Caution: Normally, the host system
			will request and process send data and
			then perform error recovery
9	1	0	LUN reports a “unit attention”	0
			condition on a non-removable media
			device
11	1	1	ADIC Management Console reports a	4
			temperature change (event message
			indicates the change to High, Very
			High, Reduced, to High, or OK
13	1	1	SNC 5100 is shutting down as	0
			requested by the ADIC Management
			Console
			(a Restart was requested)
14	0	0	Additional status information used for	0
			diagnostics

36 Event Codes and Actions

6-00020-02