ADIC Scalar 1000, SNC 5100 manual Device Access MAP

SNC 5100

that are not currently attached will be removed from the database. You must reboot the SNC 5100 after performing this procedure for the changes to take effect.

Step 1. Connect a service terminal to the SNC 5100.

For information about how to do this, see “Connecting to the

Service Port” on page 95.

Step 2. Press the Enter key on the service terminal.

If the prompt is not displayed, go to “Service Port MAP” on page 75.

Step 3. From the service terminal, enter the mapShowDatabase command to display the contents of the database.

For more information, see “mapShowDatabase” on page 146.

Step 4. From the service terminal, enter the mapShowDevs command to display LUN assignments for the attached devices that have been mapped.

For more information, see the "mapShowDevs" command on page 147.

Step 5. From the service terminal, enter the mapWinnowDatabase command to remove LUN assignments for devices that no longer need to be kept.

For more information, see the "mapWinnowDatabase" command on page 148.

Step 6. Reboot the SNC 5100.

Step 7. After the SNC 5100 has finished booting, repeat steps 3 and 4 to verify that all attached devices have been mapped.

Device Access MAP

Perform these steps if a host is not able to access SCSI or Fibre Channel devices.

Step 1. Connect a service terminal to the SNC 5100.

48 Device Access MAP

6-00020-02