ADIC Scalar 1000, SNC 5100 manual See the setHost port,OS

SNC 5100

Table 3: Installation Checklist

Step	Actions	Comments and References
11	Configure the Ethernet Port (Host Name,	If you are using the ADIC Management
	Address, Routes, reboot).	Console, you must configure an Ethernet
		environment.
	Observe Ethernet Link LED.
		For more information, see the ADIC
		Management Console User Guide
		Configure the Ethernet Port using
		information in Step 6 in Table 2:
		Pre-Installation Checklist.
		Refer to “Network Setup for the SNC
		5100” on page 87.
		If the Ethernet Link LED is not on, go to
		“Ethernet MAP” on page 69.
12	Issue hostTypeShow command from	See the "hostTypeShow" command
	the service terminal to view host type
	settings for the Fibre Channel ports.	on page 138.
	If the hosts that will be connected are not	See the "setHost [port],“OS”"
	the type shown, issue setHost	command on page 162.
	command from the service terminal to
	set the host type for each Fibre Channel
	port.
13	Power down the FC host(s).	If the FC1 and/or FC2 Connection Status
		LED for the attached host(s) is not on,
	Connect the FC cables from the FC	check FC cables. You may have to change
	HBA(s) to the SNC 5100.	the polarity of the FC cables. If the
		problem persists, go to “Fibre Channel
	Power up the FC host(s).	MAP” on page 61.
14	Issue the fcShow command from the	See the "fcShow [level]"
	service terminal to show the status of the	command on page 127.
	FC interface that is installed and
	connected.	Look for FW State=Ready for each FC
		interface. If FW State NOT=Ready, go to
	Issue fcShowDevs command from the	“Fibre Channel MAP” on page 61.
	service terminal to show SCSI target
	devices that are connected as seen by the	See the "fcShowDevs" command on
	Fibre Channel interface.	page 129. If all devices are not shown, go
		to “SCSI Channel MAP” on page 50.

22 Installation Procedure

6-00020-02