ADIC Scalar 1000, SNC 5100 manual Start MAP, Event Viewing Levels, Event Code or Obvious Symptom

	SNC 5100
	Table 8: Action Reference Table
Action
Number	Action

7Go to “Ethernet MAP” on page 69

8Go to “Service Port MAP” on page 75

9Contact your network administrator

10Reduce the number of target devices attached to the SNC 5100

11Go to “Start MAP” on page 42

12Go to “Device Access MAP” on page 48

13Go to “Retrieving the Code 43 Dump File” on page 189

Event Viewing Levels

Numerical equivalents for the Event viewing levels from the Viewing Level column of Table 8 are explained in Table 9.

		Table 9: Event Viewing Levels
Number	Level		Explanation
0	Notice		Events recorded in the Event Log but not displayed by the
			Event Viewer
1	Warning		Includes events that should always be reported, such as
			device removals, and changes to temperature or power
			systems
2	Information		Includes events that might result in later problems

Start MAP

Gather as much information as possible before performing a repair action. When gathering information, you may need to connect the service terminal to the service port. See “Connecting to the Service Port” on page 95.

For the latest information on the SNC 5100, visit www.adic.com.

Event Code or Obvious Symptom

Either an Event Code has been reported by the ADIC Management Console or an error has been observed by other means.

42 Start MAP

6-00020-02