ADIC SNC 5100, Scalar 1000 manual Host Utility Software

SNC 5100

Table 3: Installation Checklist

Step	Actions	Comments and References
15	Verify all target devices are available to	Use appropriate host system utilities for
	the host system.	disk and tape. See Table 4.
		If all devices are NOT available, reboot
		host system(s) and check again.
		If problem persists, go to “Start MAP” on
		page 42.

Host Utility Software

Table 4: Host Utility Software

Platform	Host Utility Software Name	Host Utility Software Function
Windows	Disk Administrator	show attached devices
	SCSI Adapter control panel applet	show installed scsi adapters
	Tape Devices control panel applet	show installed tape device drivers
Solaris	st.conf1	specify LUNs to be scanned for tape
		devices1
	reboot -- -r	rescan
	ls/dev/rmt	show mapped tape devices
AIX	lsdev -Cc tape	list all tape devices
	lsdev -Cc adapter	list all adapters
	rmdev - dl fcs[n] -R	remove devices no longer present
	where [n] is the
	number of the device	reconfigure
	cfgmgr
HP-UX	ioscan -C disk	scan for devices
NOTE:

1Because systems vary it is generally not possible to just replace the existing sd.conf or st.conf with a new one. Therefore you will have to add multiple LUN entries for SCSI ID 0 to sd.conf. After the existing line:

name=”st” class=”scsi” target=0 lun=0; add lines of the form:

name=”st” class=”scsi” target=0 lun=1;

until you have as many lines as are needed, one line per storage device or volume. Be sure to increase the LUN number appropriately.

Installation Procedure 23

6-00020-02