ADIC SNC 5100 Reboot, ReserveShow level, ReserveShow Viewing Levels, Reset, Level Explanation

SNC 5100

reboot

The reboot command requests that the SNC 5100 shut down existing operations and then restart. This is the preferred method of restarting the SNC 5100. There are processes running within the SNC 5100 that may have writes pending to files within the flash file system. Following a reboot command, these processes flush their data to the flash file system, and the flash file system writes all pending data out to the flash memory. Only after all pending data has successfully been written to flash, will the SNC 5100 start a reset cycle.

SN60023 > reboot

reserveShow [level]

The reserveShow command outputs a list of devices with reservations.By adding the flag “1” a list of all devices is output.

Table 15: reserveShow Viewing Levels

Level	Explanation
<blank>	Show target devices with reservations
1	Show all target devices regardless of whether a reservation is
	held or not

SN600393 > reserveShow
Idx Tdev	Vendor	Product	Rev	Reservation ITL
Host's Port Name
----------------------------------------------				--------
value = 0 = 0x0
SN600393 > reserveShow		1
Idx Tdev	Vendor	Product	Rev	Reservation ITL
Host's Port Name
----------------------------------------------				--------
0 0x8fda380 ADIC		SNC 5100	40b5
1 0x9ffcf08 IBM		DNES-309170W	SA30
value = 0 = 0x0
SN600393 >

reset

The reset command immediately initiates a reset cycle. Any pending data

Commands 151

6-00020-02