ADIC SNC 5100, Scalar 1000 manual Service Port MAP, If both addresses are the same, go to step

SNC 5100

If both addresses are the same, go to step 33.

Example:

SN60023 > gateAddrGet

Gateway Address set to 192.168.1.1 value = 0 = 0x0

If the network gateway address is incorrect, set it to the value provided by the network administrator using the gateAddrSet command.

For more information, see the "gateAddrSet" command on page 131.

Step 33. From the service terminal, enter the reboot command. Step 34. Wait until the SNC 5100 has finished booting.

Step 35. From the service terminal, use the ping command to PING the IP address of the ADIC Management Console Server.

For more information, see the ADIC Management Console User Guide.

Step 36. From the host running the ADIC Management Console Server, PING the SNC 5100.

If both PING tests succeed, exit this MAP.

If a PING test fails, inform the network administrator to check and correct the network connection, route tables, and network gateway addresses for both the ADIC Management Console Server and the SNC 5100.

Service Port MAP

These steps are performed if the SNC 5100 boots and responds to the ADIC Management Console, but the Service Port does not respond.

For more information, see the ADIC Management Console User Guide.

Service Port MAP 75

6-00020-02