ADIC SNC 5100, Scalar 1000 manual Removing and Replacing the Unit, Removing the SNC

SNC 5100

Caution

Shut down the host systems to ensure that all I/O through the SNC 5100 has stopped.

Step 1. Verify that the latest configuration has been saved.

For more information on saving the configuration, see the ADIC Management Console User Guide.

Step 2. Shut the SNC 5100 down and disconnect the power cord.

Step 3. For each cable attached to the SNC 5100, repeat the following:

-Remove the cable.

-Mark what the cable was connected to (for example, SNC 5100 number 3, SCSI channel 1).

-If the final cable has been removed, then return to the MAP that sent you here, or continue with "Removing and Replacing the Unit".

Removing and Replacing the Unit

Caution

Follow all ESD-sensitive parts procedures while performing this procedure. For ESD information, see “Handling Electrostatic Discharge-Sensitive Parts” on page 81.

This procedure describes how to remove and replace the SNC 5100.

Removing the SNC 5100

Step 1. Complete all steps in “Before Removing or Replacing the Unit” on page 82.

Step 2. After the final cable has been removed, pop off the plastic rack-mount bezel, if installed on your unit. Pull it straight out to detach it.

Step 3. Unscrew the four 4-40 x 3/8" screws that hold the units to the rack bracket.

Removing and Replacing the Unit 83

6-00020-02