ADIC Scalar 1000, SNC 5100 Special Procedures, Restoring Normal Mode, Manual Health Check

SNC 5100

	If the command prompt displayed on the service terminal is not
	diagmode >, enter the diagBoot command.
Step 7.	Wait for the SNC 5100 to reboot.
Step 8.	At the diagmode > prompt, proceed with the appropriate
	diagnostic tests.

Restoring Normal Mode

Follow this procedure if the SNC 5100 was placed in diagnostic mode and needs to be restored to normal operation.

Step 1. Connect the terminal to the Service Port, if it is not already connected.

Step 2. If it is not already on, turn on the SNC 5100 and wait for it to finish booting.

Step 3. From the service terminal, type the normalBoot command.

Step 4. Wait for the SNC 5100 to reboot.

Step 5. At the command prompt, continue with the MAP that sent you here.

Special Procedures

This section contains information on special procedures.

Health Check

The Health Check function provides a method to periodically determine the operational state of an SNC 5100 and its attached interfaces and devices.

Manual Health Check

Health Check is performed manually from the service terminal only if the SNC 5100 is in normal mode.

See “Perform Health Check” on page 46, for instructions.

188 Special Procedures

6-00020-02