ADIC Scalar 1000, SNC 5100 manual Start the Adic

			SNC 5100
Table 4-1: Post-Repair Checklist
Step		Actions		Comments and References
8	Perform the following:			This step must be performed if you replaced the SNC
	•	Start the ADIC		5100
		Management		For more information, see the ADIC Management
		Console Server and
		Client.		Console User Guide.
	•	Log on with
		administrator
		privileges.
	• Connect to the SNC
		5100.
	•	If you downloaded
		new operating
		software in Step 5 of
		“Updating the SNC
		5100” on page 90,
		update the
		firmware.
	•	Load the
		configuration file
		you saved in Step 1
		of “Before
		Removing or
		Replacing the Unit”
		on page 82 into the
		SNC 5100.
	•	Restart the SNC
		5100.
9	Reconnect the FC cables			If FC1 and/or FC2 Connection Status LEDs for the
	or, if you turned off the			attached hosts are not on, check the FC cables.
	FC hosts, turn them back
	on.			You may have to change the polarity of the FC cables.
				If the problem persists, go to “Start MAP” on page 42.

92 Post-Repair Checklist

6-00020-02