ADIC Scalar 1000, SNC 5100 manual Installation Procedure, Installation Checklist

SNC 5100

Table 2: Pre-Installation Checklist

Step	Actions	Comments and References
5	Label both ends of each SCSI cable	None.
	with:
	° Drive ID and SNC 5100 connector
	number
6	If you are using the ADIC	For more information, see the ADIC
	Management Console to manage the	Management Console User Guide.
	SNC 5100, configure an Ethernet
	environment. Decide on network	Obtain the network parameters from
	parameters:	your network administrator.
	Ethernet port configuration decisions:
	Static IP address____________	Caution: Use of incorrect network
	Netmask (if required)_________	parameters can cause problems on the
	User-defined SNC 5100 name	Ethernet network.
	(optional)__________________
		The default network name is the unit’s
	You may need to assign a default	serial number. If you choose a different
	network gateway address and/or route	name, it becomes the prompt displayed
	table entries:	on the service terminal. Choosing a
	________________________	different name may be useful if you have
	Caution: Save this configuration	more than one SNC 5100. To change the
	information for future reference.	name, use the "hostNameSet"
		command on page 138.
7	If you are using the ADIC	For more information, see the ADIC
	Management Console to manage the	Management Console User Guide.
	SNC 5100, run the Ethernet cable
	from the server (the computer that is
	designated to run the management
	software’s Server) to the network hub.

Installation Procedure

The installation checklist has instructions on how to install the SNC 5100 with SCSI attached storage and Fibre Channel attached hosts.

Table 3: Installation Checklist

Step	Actions	Comments and References
1	Acquire information for Ethernet	Refer to Step 6 in Table 2: Pre-Installation
	installation.	Checklist.

20 Installation Procedure

6-00020-02