ADIC Scalar 1000, SNC 5100 manual NormalBoot, Rdate timeserver

SNC 5100

inetstatShow		- Display all Internet			protocol sockets
ipstatShow	-	Display statistics		for	IP
macShow	- Display Media		Access	Control Address
mbufShow	- Display mbuf		statistics

route "<func>","destination","gateway" func - "add" - add route to route table

-"delete" - delete route from route table

-"list" - list route table

tcpstatShow - Display statistics for TCP udpstatShow - Display statistics for UDP

See User’s Guide for more information

value = 0 = 0x0 SN60023 >

normalBoot

Certain commands and tests are only available in diagnostic mode. Switching to diagnostic mode saves all configuration parameters so that they are restored before returning to normal operation. Use the normalBoot command to restore the SNC 5100 to normal operating conditions.

This command is used only to transition an SNC 5100 from the special diagnostic mode to normal operations. It restores the bootline that was copied by diagBoot. The new persistent device map is erased, and the original map file is renamed config/device.map restoring it for use when the SNC 5100 reboots. The normalBoot command will then reboot the unit.

rdate “timeserver”

The rdate “timeserver” command sets the system date and time to be read from a remote system. The "setTimeHost" command on page 164 must already have been entered before the rdate “timeserver” command is issued. To see data from the new setting, use the date command. To set the date and time to be read from a remote system named “Cronos,” enter the following command:.

SN60023 > rdate “Cronos” value = 0 = 0x0 SN60023 >

150 Commands

6-00020-02