ADIC Scalar 1000, SNC 5100 manual Verify Host Access to Devices

SNC 5100

For more information, see the "licenseShow" command on page 141.

Example:

License "s2zhq-7xdhd": Valid

Features:

SFM

Value = 2 = 0 x 2

Step 7. If the output from the licenseShow command shows that SFM is Valid, as in the example, proceed to Step 8.

If the output from the licenseShow command shows that SFM is not Valid, exit this MAP and contact your service representative.

Step 8. Use the ADIC Management Console to verify the host and target device access settings.

For more information, see the ADIC Management Console User

Guide.

Exit this MAP.

If the ADIC Management Console is not available, you can temporarily make SFM inactive to verify that the host can access all devices. Proceed to "Verify Host Access to Devices".

Verify Host Access to Devices

Step 1.	Shut down all of the hosts.
Step 2.	Enter the sfmInactive Set command from the service terminal.
	For more information, see the "sfmInactiveSet" command on
	page 167.
Step 3.	Startup one of the hosts.
Step 4.	If the host can access all of the target devices, shut down the host
	and repeat steps 2 and 3 for each of the other hosts.
	If each host can access all devices then there is a problem with the
	Scalar Firewall Manager Access settings. Go to step 5.

78 Virtual Private SAN®Scalar Firewall Manager Settings MAP

6-00020-02