ADIC Scalar 1000, SNC 5100 manual EnableCC, EnvMonShow, Channel Name Description

SNC 5100

enableCC

To restore the capability to send commands to the command and control interface (LUN 0), use the enableCC command. The command is typically used to re-enable the interface after it was disabled by the disableCC command.

SN60023 > enableCC value = 0 = 0x0 SN60023 >

envMonShow

The envMonShow command lists all of the environmental channel states and their current values. Use the command envMonRangeShow to restrict output to a display of the ranges relevant to each state. The following channels have been defined:

Channel Name			Description
Air Inlet Temp			Temperature of the air as it enters the unit
Air Outlet Temp			Temperature of the air as it exits the unit
IO Processor Temperature			Temperature of the IO Processor
Input Power: ± 5 Volts			Voltage level of the ± 5 input
Input Power: ± 12 Volts			Voltage level of the ± 12 input
Local Power: ± 2.5 Volts			Voltage level of the local 2.5 supply
Local Power: ± 3.3 Volts			Voltage level of the local ± 3.3 supply
Local Power: ± 3.3 Volts			Voltage level of the local auxiliary ± 3.3 supply
Aux
Channel Name			Description
Fan			Fan running (for tachometer fans: RPM of fan)
SN60023 > envMonShow
Channel	State	Value

------------------------------------------------------

Air Inlet Temperature Nominal 44 C

118 Commands

6-00020-02