ADIC SNC 5100, Scalar 1000 manual EthAddrSet, FcConnTypeGet port, Parameter Value Meaning

SNC 5100

ethAddrSet

The ethAddrSet command changes the IP address of the SNC 5100. An IP address is specified as 4 decimal numbers separated by periods.

SN60023 > ethAddrSet "192.168.1.54"

Host Address set to 192.168.1.54 for Ethernet interface value = 0 = 0x0

SN60023 >

If a netmask is required, specify it after the IP address in “dotted decimal” form.

For example:

SN60023 > ethAddrSet "10.0.0.2","255.255.0.0" Inet Mask set to ffff0000 for Ethernet interface Write complete

Host Address set to 10.0.0.2 for Ethernet interface value = 0 = 0x0

SN60023 >

fcConnTypeGet [port]

The fcConnTypeGet command is used to display the current setting of a Fibre Channel port’s connection type. See also the fcConnTypeSet command.

Parameter	Value	Meaning
port	1	The SNC 5100 Connection labeled FC1
	2	The SNC 5100 Connection labeled FC2
connection type	0	Loop
	1	Point-to-point
	2	Loop preferred

The following example shows how the connection type is displayed when Fibre Channel port 1 is specified and its connection type is loop.

SN600012 > fcConnTypeGet 1 value = 0 = 0x0 SN600012 >

Commands 121

6-00020-02