Foundry Networks FGS624P, FGS624P-POE, FGS624XGP, FGS624XGP-POE, FGS648P, FGS648P-POE Cleaning the Fiber-Optic Connectors

FastIron GS Compact Layer 2 Switch Hardware Installation Guide

You must install a fiber optic module (SFP or XFP transceiver) in each Gigabit Ethernet and 10-Gigabit Ethernet

fiber port you want to use.

You can install a new fiber optic module in a port while the Foundry device is powered on and running.

To install a fiber optic module, you will need an ESD wrist strap with a plug for connection to a metal surface.

WARNIN G: For safety reasons, the ESD wrist strap should contain a series 1 meg ohm resistor.

To install a fiber optic module, do the following:

1. Put on the ESD wrist strap and ground yourself by attaching the clip end to a metal surface (such as an

equipment rack) to act as ground.

2. Remove the new module from its protective packaging.

3. Gently insert the fiber optic module into the port until the module clicks into place. The module is keyed to

prevent incorrect insertion.

To cable a fiber optic module, do the following:

1. Remove the protective covering from the fiber-optic port connectors and store the covering for future use.

2. Before cabling a fiber optic module, Foundry strongly recommends cleaning the cable connectors and the

port connectors. See “Cleaning the Fiber-Optic Connectors” on page 7-16.

3. Gently insert the cable connector(s) (a tab on each connector should face upward) into the port connector(s)

until the tabs lock into place.

4. Observe the link and active LEDs to determine if the network connections are functioning properly. For more

information about the LED indicators, see Table 4.2 on page4-7.

Cleaning the Fiber-Optic Connectors

To avoid problems with the connection between the fiber optic module (SFP (mini-GBIC) or XFP) and the fiber

cable connectors, Foundry strongly recommends cleaning both connectors each time you disconnect and

reconnect them. In particular, dust can accumulate in the connectors and cause problems such as reducing the

optic launch power.

To clean the fiber cable connectors, Foundry recommends using the fiber-optic reel-type cleaner that shipped with

your Foundry chassis. You can also purchase this type of cleaner from the following Website:

http://www.fisfiber.com

When not using an SFP or XFP connector, make sure to keep the protective covering on.

Foundry Networks Cleaning the Fiber-Optic Connectors