Foundry Networks FGS648P-POE, FGS624P-POE, FGS624XGP-POE manual Retaining Bale AC Power Cord

Installing the FastIron GS Chassis

4.With one hand, hold the bar on the front panel of the power supply. With the other hand, support the underside of the power supply, and insert the power supply into the empty power supply slot. Press until the supply is completely in the slot, so that the connectors on the back of the supply fully engage with the pins on the power backplane.

CAUTION: Make sure you insert the power supply right-side up. It is possible to insert the supply upside down, although the supply will not engage with the power backplane when upside down. The power supply is right-side up when the power connector is on the left and the fan vent is on the right.

5.Press the two latches near the edges of the supply outward to lock the supply in place.

6.Replace the power supply locking screw.

7.Install the power cord, as shown below.

Retaining Bale AC Power Cord

September 2007 © 2007 Foundry Networks, Inc. 3 - 7