Foundry Networks FGS624P-POE, FGS648P-POE Installing a POE Daughter Card, Removing the Top Cover

FastIron GS Compact Layer 2 Switch Hardware Installation Guide

•Gently lift the cover off of the chassis as shown in Figure 7.6.

Figure 7.6 Removing the Top Cover

5.Proceed to “Installing a POE Daughter Card” .

Installing a POE Daughter Card

To replace or install the POE daughter card, do the following:

1.Disassemble the FGS chassis as instructed in the section “Disassembling the Chassis” on page 7-11.

2.If you are replacing the POE daughter card, remove the existing card from the connector slot on the main board. Figure 7.8 and Figure 7.9 show the locations of the POE daughter cards on the main board of the FGS624P-POE and the FGS648P-POE.

3.Install the new POE daughter card:

•Remove the POE daughter card from its packaging. The POE daughter card is keyed to prevent improper insertion, as shown in Figure 7.7.

Figure 7.7 POE Daughter Card

•Locate the connector slots for the POE daughter card on the main board (Figure 7.8 and Figure 7.9).

7 - 12 © 2007 Foundry Networks, Inc. September 2007