FastIron GS Compact Layer 2 Switch Hardware Installation Guide
3 - 6 © 2007 Foundry Networks, Inc. September 2007
You will need the following tools to perform these procedures:
• #2 Phillips-head screwdriver
Installing an AC Power Supply
WARNIN G: Before beginning the installation, see the precautions in “Power Supply Precautions” on page3-4.
Use the following procedures for installing AC power supplies in the FastIron GS.
To install an AC power supply, do the following:
1. If necessary, remove the power supply locking screw located in the center rear of the device (illustrated
below).
2. If the empty power supply bay has a cover plate, press inward on the two latches near the left and right edges
of the cover plate to unlock the plate (illustrated below), then remove the plate.
3. Remove the new power supply from its packaging.
Power supply
locking screw
Latches