84
Northstar 8000i System -12" Display Processor Installation Manual
7. Select Software Upgrade
8. When the upgrade screen appears select OK to continue. or Cancel. (optionally use
the Tick or X on the keypad to continue or cancel)
9. When the system has finished copying files you will be prompted to remove the
USB pen drive and power down the processor
10. Start the processor for the changes to take effect
1. Upgrade the Software on the Master Processor First as outlined above. if you
don't want to upgrade the other processors at this stage power them down before
upgrading the master.
NOTE: All processors on the network must have the same software version. Once the master
has being upgraded, all other units wont function until they have being upgraded
Software patch: multi-processor system Client. 1. Once the master has been upgraded. Power up the client processor. The upgrade
will commence automatically. Files will be copied from the master and installed on
to the client.
2. If the client processor was running when the master was upgraded it will display
am message saying the software is incompatible with the master and prompt you
to upgrade. Power down the unit and restart. The upgrade will commence
automatically
1. Start the 8000i processor and wait till system has finished loading and is running
normally
2. Back up user settings (recommended)
3. Make sure there are no USB pen drives or other USB mass storage devices attached
to the system. This can cause problems and possibly result in a mass storage device
losing its data
4. Start the 8000i processor and wait till system has finished loading and is running
normally
5. Make sure the 8000i DVD is connected to the processor being upgraded. Insert the
image DVD (this can be obtained from your Northstar dealer.
6. Select
Display.
7. Select
Installation.
8. Select
Software upgrade
9. Acknowledge that there is no software upgrade available and go to image upgrade
page by selecting OK