WCV | Waypoint Closure Velocity |
|
|
WPL | Waypoint Location |
|
|
XTE | |
|
|
ZDA | Time and Date |
|
|
10.10 Set NMEA Baud Rate
The baud rate for NMEA in and out can be changed between 4800 and 19200
To select NMEA Output sentences:
1.Select Display.
2.Select Setup from the control panel.
3.Select + installation to display a list of installation specification options.
4.Select NMEA Baud Rate
5.The NMEA Baud Rate button shows the current setting. Select the button if you want to change the setting and a drop down list of choices appears.
6.Select the new setting. The new setting is applied immediately and stays until you change it again.
10.11Calibrate the touch screen
You can calibrate the touch screen so that the cursor is lined up with your finger more accurately. This makes it easier to select items on the screen.
To calibrate the touch screen:
1.If you are using a 12" Display Processor, press the Power key briefly to display a list of options, then use the directional arrows to select Calibrate Touch Screen.
2.Press the tick key to start the calibration process, then see Step 5.
Alternatively, or if you are using a 15" Monitor:
1.Select Display.
2.Select Setup from the control panel.
3.Select + System to display a list of system options.
4.Select Calibrate next to Calibrate Touch Screen.
5.Follow the instructions on the screen. (If you want to be able to select the buttons at the bottom of the screen easily, you must touch the center of the targets.) When the cursor follows your finger across the screen, select the green arrow. This ends the calibration process.
6.When you are finished, select – System.
10.12Set the device (processor) name
The processor name can be changed to help identify it one the network. eg STARBOARD or FLYBRIDGE. If you change the processor name, the 8000i must be restarted to apply the new setting.
To set the processor name:
1.Select Display.
2.Select Setup from the control panel.
3.Select + System to display a list of system specification options.
4.The Device Name button shows the current setting. Select EDIT if you want to change the setting and enter the new name using the onscreen keyboard.
Northstar 8000i System - 12" Display Processor Installation Manual | 71 |
