Foundry Networks FGS648P-POE, FGS624P-POE, FGS624XGP-POE manual Installing an AC Power Supply

FastIron GS Compact Layer 2 Switch Hardware Installation Guide

Installing an AC Power Supply

To install an AC power supply, do the following:

1.If necessary, remove the power supply locking screw located in the center rear of the device (illustrated below).

Power supply locking screw

Latches

2.If the empty power supply bay has a cover plate, press inward on the two latches near the left and right edges of the cover plate to unlock the plate (illustrated above), then remove the plate.

3.Remove the new power supply from its packaging.

4.With one hand, hold the bar on the front panel of the power supply. With the other hand, support the underside of the power supply, and insert the power supply into the empty power supply slot. Press until the supply is completely in the slot, so that the connectors on the back of the supply fully engage with the pins on the power backplane.

CAUTION: Make sure you insert the power supply right-side up. It is possible to insert the supply upside down, although the supply will not engage with the power backplane when upside down. The power supply is right-side up when the power connector is on the left and the fan vent is on the right.

The following illustrations show how to install an AC power supply.

7 - 4 © 2007 Foundry Networks, Inc. September 2007