Versa•Touch2®
SAFEty first
Warning: To reduce the risk of electrical shock, this fan must be installed with an isolating wall control/switch.
VERSA•TOUCH2 ♦ INSTALLATION
control
holder
| |
control | 12v BAttery |
DRYWALL | wood | screw | screw |
ANCHOR | screw | ||
1” (2) | (2) | (2) |
VERSA•TOUCH2 ♦ CONTROL BRACKET INSTALLATION
CAUTION! Do not use with wall dimmer.
standard
toggle switch
Inner
Mounting
holes
switch
cover plate
control bracket
Standard Light Switch
Step A. Remove the two screws holding the switch cover plate. Do not remove the cover plate.
Step B. Orient the control bracket as shown and line up the two inner mounting holes with those on the switch.
Step C. Install and tighten screws by hand only.
Wall Installation
Step A. Locate a 2x4 wall stud in a convenient
location .
Step B. Orient the control bracket as shown over the
Rocker
Type
Light
switch
Outer
Mounting
holes
| switch |
control | cover |
plate | |
bracket |
|
Rocker Light Switch
Step A. Break off the two tabs by pushing outward.
Step B. Remove the two screws holding the switch cover plate. Do not remove the cover plate.
Step C. Orient the control bracket as shown and line up the two inner mounting holes with those on the switch.
Step D. Install and tighten screws by hand only.
Note: The wall anchors and
2x4 stud.
Step C. Use the 1” wood screws in either the inner or outer mounting holes. Install and tighten screws by hand only.
Anchor
Panhead
Screw
wood
screw 1”
DRYWALL ANCHOR
Decor Ovalhead screw
Changes or modifications not expressly approved in writing by Casablanca Fan Co. may void the user’s authority to operate this equipment.
This device complies with
(2)this device must accept any interference, including interference that may cause undesired operation of the device.
12