FAN PREPARATION
IMPORTANT SAFETY INFORMATION!
Before starting the installation of your ceiling fan, install the threaded
downrod into the motor coupling and lock the assembly
Prepare for fan installation as follows:
Step 4a. Place the motor cover on the downrod as shown.
Step 4b. Route the wires from the motor through the Perma Lock™ downrod and ball assembly.
Tip: The downrod has a tapered thread that is designed to lock completely when correctly installed.
Step 4c. Using the provided Allen wrench, loosen the set screw several turns to allow installation of the downrod. Thread the downrod into the motor coupling until it stops turning. This will take at least four and a half full turns.
Step 4d. Tighten the set screw securely with the provided Allen wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the downrod before securely tightening the Allen set screw may cause the fan to separate from the downrod during normal operation!
Step 4e. Slide the motor cover down so that it is flush against the top of the fan.
Step 4f. Using the three provided screws, attach the motor cover to the motor. Tighten securely with the provided Phillips screwdriver.
Step 4g. Unsnap one of the switch housing brackets on the bottom of the switch housing and set it aside for use in step 6c.
Step 4h. To reach the blade holder mounting holes in the fan motor, the switch housing cap must be removed. Take out the two
Perma•Lock™ Downrod
and Ball Assembly
Allen Set Screw
Motor Coupling
Tapered Thread
| Switch |
| ousing |
| racket |
Mount Screws | Switch |
(2) | Housing | |
Cap | ||
|
6
