REMOTE OPERATION
Fan Control
To start the fan. Press the selected speed button to run the fan at the desired speed.
1=Low speed 2=Medium speed 3=High speed | Dow |
Ligh | |
To turn off the fan. Press the FAN OFF button. | M |
Airflow Direction |
|
To reverse the airflow press the REVERSE button. Reverse operates at any speed whether | L |
fan is on or off. The fan returns to its set speed after reversing. |
|
Light Control |
|
Turn the light on or off independently from the fan by pressing the UP LIGHT DOWN |
|
LIGHT OR BOTH button. (This is a rocker switch. Press the left side for the Down |
|
Light, right side for the Up light , and the middle for both.) Keep pressing the button |
|
in excess of 0.7 seconds, it becomes a dimmer. The light varies from ‘bright’ to ‘dim’ over |
|
approximately 8 seconds.This sequence will reverse the light when it reaches the brightest |
|
or dimmest level if you continue to hold the LIGHT button. Release the button when |
|
the desired level is reached. |
|
Auto Resume
Quick (pressing less than 0.7 seconds) on/off operation of the LIGHT button maintains the desired brightness level set previously.
TRANSMITTER FREQUENCY SETTING
p 
ht
H
n
f
Note: All fans leave the factory set to ‘00000’. |
|
You will only have to change the dip switch settings in the remote if you are using more |
|
than one fan in the same area and want to control them separately. |
|
Step 1. At the circuit breaker or fuse box, turn the power off for the fan you want to |
|
change. |
|
Step 2. Open the battery door of the Versa•Touch control and remove the battery. |
|
Step 3. Change the dip switch settings, assuring that they are different from the previously | versa•touch 2 control |
installed Versa•Touch fan. | (back) |
Step 4. |
|
Step 5. At the circuit breaker or fuse box, turn the power back on for the fan whose |
|
frequency you are changing. |
|
Step 6. Within 20 seconds of restoring power, push the Hi, Med, and Lo buttons (in | Dip Switch | Dip Switch | |
that order). |
| Set to ‘10000’ | Set to ‘01001’ |
|
| ||
HELPFUL HINT: Label your controls to | Within 20 seconds of turning | MEDIUM |
|
the fan on, press in this orderr to |
| ||
ensure you do not mix them up. | set new frequency: |
|
|
| 3 - HIGH |
|
|
WARNING: Do not turn the power off at the circuit breaker, then | 2 - MED |
|
|
1 - LOW |
|
| |
back on, for the previously installed Versa•Touch 2 fan(s), as you | LOW |
|
|
may inadvertantly change the frequency settings for it as well. |
| HIGH | |
|
|
| |
IF FAN DOES NOT WORK
If the fan is not functioning after installation:
1.Check to make sure that batteries are installed correctly in the control.
2.Turn the power off to the fan (from the circuit breaker) for at least FIVE seconds.
3.Turn the power back on (at the circuit breaker) and push the High, Medium, and Low
4.The fan should now function properly.
|
| MED |
|
| LO |
| HIGH |
| press in this order to set new | ||
Circuit Breaker |
| frequency: |
|
or Fuse Box | HIGH | MED | LOW |
11
