Mixer Function

Editing DSP Channel Parameters

1. While Channel 16 is selected, press the [ ] CURSOR button.

•This selects the DSP channel.

•Pressing the [ ] CURSOR button while the DSP channel is selected returns to Channel 16.

How Parameters Work

The following are the parameters whose settings can be changed in the Parameter Edit Mode.

Tone Parameters

zTone (Range: 000 to 903, Drawbar organ tones 000 to 199)

This parameter controls the tones assigned to each part. Anytime the tone is on the display, you can use the TONE button or DRAWBAR ORGAN button and then select a different tone, if you want.

S t . G r P n o

zPart On/Off (Settings: on, oFF)

This parameter can be used to turn each part on (sounds) and off (does not sound). The current on/off status of each part is indicated on the display as described below.

C h a n n e l

zVolume (Range: 000 to 127)

This is the parameter that controls the volume of the selected channel.

zOctave Shift (Range: –2 to 0 to +2)

You can use octave shift to shift the range of the tone up or down. When using the piccolo tone, there may be cases when very high notes you want to play are not included within the range of the keyboard. When this happens, you can use octave shift to shift the keyboard range one octave up.

O c t S h i f t

–2 :Range shifted two octaves down.

–1 :Range shifted one octave down.

0 :No shift

+1 :Range shifted one octave up.

+2 :Range shifted two octaves up.

Tuning Parameters

You can use these parameters to tune each of the parts individually.

zCoarse Tune (Range: –24 to 00 to +24)

This parameter controls the coarse tuning of the selected channel’s pitch in semitone units.

C . T u n e

zFine Tune (Range: –99 to 00 to +99)

This parameter controls the fine tuning of the selected channel’s pitch in cent units.

F i n e T u n e

V o l ume

zPan Pot (Range: –64 to 00 to +63)

This parameter controls the pan pot, which is the center point of the left and right stereo channels. Setting “00” specifies center, a value less than “00” moves the point left, and a value greater than “00” moves it right.

Effect Parameters

The Mixer lets you control the effects applied to each individual part, making it different from the Effect Mode, whose settings are applied to all parts in general.

zReverb Send (Range: 000 to 127)

This parameter controls how much reverb is applied to a part. A setting of “000” turns reverb off, while a setting of 127 applies maximum reverb.

• “Reverb Send” does not work with some drum sounds.

P a n

R v b S e n d

E-38

707A-E-040A