Synthesizer Mode
Parameters and Their Settings
Use the following procedure to select a preset tone and change its parameters to create a user tone.
1. First, select the preset tone you want to use as a basis for your user tone.
2. Press the SYNTH button.
•This enters the Synthesizer Mode, which is indicated by the pointer next to SYNTH on the display screen.
|
| A t k T i me | |
|
|
|
|
1 | 2 |
1Parameter setting value
2Currently selected parameter
3.Use the [ ] and [ ] CURSOR buttons to display the parameter whose setting you want to change.
The following describes the function of each parameter and provides its setting range.
zAttack Time (Range:
Time it takes before the tone sounds after a key is pressed
A t k T i me
zRelease Time (Range:
Time the tone continues to sound after a key is released
R e l . T i me
zCutoff Frequency (Range:
V i b D e l a y
•Each press of the [ ] or [ ] CURSOR buttons changes to the next parameter. See “Parameters and Their Settings” on page
4.Use [+] and
•You can also use the number buttons to input a value to change a parameter setting. See “Parameters and Their Settings” on page
5.After you are finished editing the sound, press the SYNTH button to exit the Synthesizer Mode.
•See “Storing a User Tone In Memory” on page
C - o f f F r q
zResonance (Range:
R e s o n a n .
zVibrato Waveform (Range: See below.) Specifies the vibrato waveform.
V i b . T y p e
Value | Meaning | Waveform |
Sin | Sine Wave |
|
tri | Triangle Wave |
|
SAU | Sawtooth Wave |
|
Sqr | Square Wave |
|