Unpacking

EA-200

Soft case

Data communication cable

 

 

(SB-62)

Temperature probe

Optical probe

Voltage probe

Four AA-size alkaline batteries AC adaptor

User’s Guide (this manual)

 

EA-200

 

User’s Guide

 

http://world.casio.com/edu_e/

Using the Soft Case

2

1

0-3

English

About the EA-200

The EA-200 is a digital device that makes it possible for you to sample data connected with everyday natural phenomena.

Data You Can Sample with the EA-200

Various different sensors can be used with the EA-200 to sample temperatures, light, voltage, distance, and other data. The EA-200 supports sampling of up to 120,000 points, and simultaneous sampling over five channels. Sampled data can be sent to a compatible Graphic Scientific Calculator, where it can be viewed and graphed.

Before Using the EA-200 for the First Time

Power Requirements

Your EA-200 requires four AA-size alkaline batteries for power. Battery life depends on the amount of time the EA-200 is left on, and the amount of current used by the connected probe(s). A low battery indicator lamp (Batt) lights to let you know when it is time to replace batteries. To extend battery life, it is a good idea to use the AC adaptor for power whenever sampling indoors.

When using the EA-200 in combination with the optional “Motion Sensor (EA-2)”, be sure to power the EA-200 using its bundled AC adaptor (AD-A60024).

Though the EA-200 can normally operate on battery power, separate AC adaptor power is required while the optional “Motion Sensor (EA-2)” is being used.

Batteries are not loaded in the EA-200 when it is shipped from the factory. Because of this, use the following procedure to load batteries into the EA-200 before using it for the first time.

To load batteries

1. Remove the battery cover by pulling with your finger at the point marked 1. If there are batteries in the battery

compartment, remove all four of them.

1

2. Load four new AA-size batteries. Make sure that the plus and minus ends of the batteries are facing in the directions shown by the markings inside the battery case. Replace the battery cover.

3.Slide the [ON/OFF] switch to turn on the EA-200. To turn off, slide the [ON/OFF] switch again.

20020601