Casio EA-200, EA200
Key Functions,
Indicator Lamps, Key Functions and Indicator Lamps, Does this:, To do this:, It means this:, Press this key:, When this indicator lamp:

Chapter 1

General Guide	Analog Channels ⋅ 3
	(Analog output for CH3 only)
	CH3	CH2 CH1
Digital input/output port			SONIC Channel
			EA-2*1
Serial 232C (9-pin) port
(for cross cable)
			Calculator 3-pin
			communication port
			(SUB port) ⋅ 7
External microphone 2-pin port
(for condenser microphone)			Calculator 3-pin
External speaker 2-pin port
			communication port
Volume
			(MASTER port)
Indicator lamps	Ready Sampling Error	Batt Power	Built-in speaker
			ON/OFF switch
	SET UP	START/STOP	P button (rear side)*2
SET UP key			START/STOP key
AC adaptor port			Built-in microphone

Data communication

*1 When using the EA-200 in combination

cable

with the optional “Motion Sensor (EA-2)”,

be sure to power the EA-200 using its bundled AC adaptor (AD-A60024).

1-1

English

Key Functions and Indicator Lamps

Key Functions

To do this:	Press this key:
Start a sampling operation from the ready state	[START/STOP]
Stop an ongoing sampling operation	[START/STOP]
Use Auto Setup (See “Auto Setup” on page 1-5.)	[SET UP]
Cancel the ready state	[SET UP]

Indicator Lamps

When this indicator lamp:	Does this:	It means this:
Power (Green)	Lights	Power is on.
Ready (Green)	Lights	EA-200 is standing by for data (ready state).
Sampling (Green)	Flashes	Sampling is in progress.
Error (Red)	Lights	An error occurred.
Batt (Red)	Lights	It is time to replace the batteries.

•While the “Ready” lamp is lit, press the [START/STOP] key to start sampling.

•To cancel the ready state, press the [SET UP] key.

•To interrupt a sampling operation, press the [START/STOP] key.

•For details about errors, see “Status Request” on page 1-5.

*2 If you start to experience serious operational problems with the EA-200, use a thin, pointed object to carefully press the P button on the back of the EA-200. Note, however, that pressing the P button deletes all data currently in EA-200 memory. Proper operation does not resume after you press the P button, remove its batteries, and then replace them correctly in accordance with the instructions on page 0-3 of the User’s Guide.

20020601