4.Image recording will continue until the end of the recording time is reached.

•While the camera is in Move Out CS recording standby, you can cancel standby by pressing the shutter button all the way down. You then will be able to shoot images normally.

•To stop an ongoing real-time recording operation, press [SET].

5.Save the CS images (page 56).

.To shoot using Move In CS

1.Compose the image at a location where you expect the subject to enter the boundary on the monitor screen.

2.Half-press the shutter button.

•The camera will adjust exposure and focus automatically.

•In this case, use of manual focus (page 91) to preset a fixed focus is recommended.

3.When the boundary on the monitor screen turns

green, press the shutter button the rest of the way down.

At this time the camera will go into recording standby and start pre-recording images and storing them in a buffer, in accordance with the Prerecord CS shots

setting you configured in step 13 under “To setup the

camera” on page 81. After the buffer becomes full, new Boundary images keep being added while older images are

continually being deleted.

The camera will start saving images to memory automatically the moment it detects the subject has moved into the area within the boundary.

•“0 AUTO” flashes on the monitor screen during recording standby and auto recording.

4.Image recording will continue until the end of the recording time is reached.

•While the camera is in Move In CS recording standby, you can cancel standby by pressing the shutter button all the way down. You then will be able to shoot images normally.

•To stop an ongoing real-time recording operation, press [SET].

84

Using BEST SHOT