Casio EX-M20 manual 106, Press the USB cradle USB button

FILE MANAGEMENT

6.Press the USB cradle [USB] button.

•This displays the print menu on the camera’s monitor screen.

7.On the camera’s monitor screen, use [ ] and

[ ] to select “Print”, and then press [SET].

•This automatically starts printing of the images you specified with the DPOF procedure.

•If you want to print the same batch of images again, press the [USB] button on the USB cradle.

•A message appears on the monitor screen, followed by the DPOF setting screen (page 102), if there are no DPOF settings currently configured on the camera to control the printing operation. If this happens, configure the required DPOF settings and then perform step 6 of the above procedure again.

•If you want to change the current DPOF settings, select “DPOF” on the print menu to display the DPOF setting screen (page 102).

8.After printing is complete, turn off the camera and remove it from the USB cradle.

IMPORTANT!

•See the documentation that comes with your printer for information about print quality and paper settings.

•Contact your printer manufacturer for information about models that support USB DIRECT-PRINT, upgrades, etc.

•Never disconnect the USB cable, or perform any camera or USB cradle operation while printing is in progress. Doing so causes a printer error.

•To interrupt an ongoing print operation, perform the required operation on the printer.

•The camera’s monitor screen will go blank after printing starts. A blank monitor screen does not necessarily mean that printing is complete. Check the status of your printer to find out if printing is complete.

106