Casio EX-Z3000 Lamp Status, Description, 3. Connect the USB, cable to the camera, Back Lamp Operation

3. Connect the USB				USB-AC adaptor
cable to the camera.
The back lamp should
light red, indicating that
charging has started.
The back lamp will go
out when charging is
complete.				USB cable
It takes about
190 minutes to bring a				(included with camera)
fully dead battery to a			[USB/AV] port
full charge.
•	A battery that has not
	been used for a long			Small connector
	time, or ambient
	temperature		Making sure that the 6 mark on the camera is aligned
	extremes can cause
	charging to take		with the 4 mark of the USB cable connector, connect
			the cable to the camera.
	longer than normal. If
	charging takes longer
	than about six hours, a timer will terminate it automatically, even if the battery is
	not fully charged. This is indicated by the back lamp flashing red. If the battery
	has not been used for a very long time, charging may be terminated
	automatically and the back lamp may start flashing red after only about 45
	minutes. In either case, disconnect the USB cable from the camera and then
	reconnect it to resume charging.
•	Note that even while the connector is fully inserted, you
	still will be able to see the metal part of the connector as
	shown in the illustration.
Back Lamp Operation
Lamp Status		Description
Lit Red		Charging
		Abnormal ambient temperature,
Flashing Red		USB-AC adaptor problem,		Back lamp
		battery problem, or charging
		terminated by timer (page 119)
Off		Charging complete

17 Quick Start Basics