Casio EX-Z3000 camera to it, 2. With your computer, turned on, connect the, .To charge using a USB connection to a computer, 1.Press [ON/OFF] (Power) to turn off the camera

4.After charging is complete, disconnect the USB cable from the camera and then unplug the adaptor from the power outlet.

.To charge using a USB connection to a computer

The battery loaded in the camera is charged whenever the camera is connected directly to a computer with the USB cable.

•Depending on the setup of your computer, you may not be able to charge the camera’s battery over a USB connection. If this happens, use of the USB-AC adaptor that comes with the camera is recommended.

IMPORTANT!

•The first time you connect the camera to your computer with the USB cable, an error message may appear on your computer. If this happens, disconnect and then reconnect the USB cable.

1.Press [ON/OFF] (Power) to turn off the camera.

2. With your computer	USB port		USB cable
turned on, connect the			(included with camera)
camera to it.
The camera’s back lamp will		Large connector
light red. After a short while,
the camera will turn on
automatically and the back
lamp will light amber to
indicate that charging has
started. The back lamp will	[USB/AV]
light green when charging is	port		Small connector
complete. Note, however,
that some computer models
or connection conditions
can produce low supply	Making sure that the 6 mark on the camera is
capacity. If low supply
	aligned with the 4 mark of the USB cable
capacity exists, charging will
	connector, connect the cable to the camera.
start without the camera

turning on. This is indicated by the back lamp lighting red. The back lamp will go out in this case after charging is complete.

• It takes about 260 minutes to bring a fully dead battery to a full charge.

B 18 Quick Start Basics