•Norm: Selecting one of the two available settings (Norm1, Norm2) determines the range in which results will be displayed in non- exponential format. Outside the specified range, results are displayed using exponential format.
Norm1:
Norm2:
Example: 1 ⎟ 200 = 5 ⋅ | (Norm1) |
0.005 | (Norm2) |
Specifying the Fraction Display Format
To specify this fraction
display format:
Perform this key operation:
Mixed1Nc1(ab/c)
Improper1Nc2(d/c)
Specifying the Complex Number Display Format
To specify this complex | Perform this key operation: |
number format: |
|
Rectangular Coordinates | 1Nc3(CMPLX)1(a+bi) |
Polar Coordinates | 1Nc3(CMPLX)2(r∠θ) |
Specifying the Statistical Display Format
Use the following procedure to turn display of the frequency (FREQ) column of the STAT Mode STAT editor screen on or off.
To specify this: | Perform this key operation: |
Show FREQ Column 1Nc4(STAT)1(ON)
Hide FREQ Column 1Nc4(STAT)2(OFF)
Specifying the Decimal Point Display Format
To specify this decimal
point display format:
Perform this key operation:
Dot (.)1Nc5(Disp)1(Dot)
Comma (,)1Nc5(Disp)2(Comma)
•The setting you configure here is applied for calculation results only. The decimal point for input values is always a dot (.).