Cisco Systems MDS 9000 manual Command Modes Command History Usage Guidelines Examples, 20-79

Chapter 20 Show Commands

show interface

Command Modes

Command History

Usage Guidelines

Examples

EXEC

This command was modified in Cisco MDS SAN-OS Release 1.3(1).

You can specify a range of interfaces by issuing a command with the following example format:

interface fc1/1 - 5 , fc2/5 - 7

The spaces are required before and after the dash ( - ) and before and after the comma ( , ).

The show interface interface-type slot/port transceiver command can only be issued on a switch in the Cisco MDS 9100 Series if the FCOT is present.

The following example displays information for a Fibre Channel interface.

switch# show interface fc1/11 fc1/11 is up

Hardware is Fibre Channel

Port WWN is 20:0b:00:05:30:00:59:de Admin port mode is ST

Port mode is ST Port vsan is 1 Speed is 1 Gbps

Rspan tunnel is fc-tunnel 100 Beacon is turned off

5 minutes input rate 248 bits/sec, 31 bytes/sec, 0 frames/sec

5 minutes output rate 176 bits/sec, 22 bytes/sec, 0 frames/sec 6862 frames input, 444232 bytes

0 discards, 0 errors

0 CRC, 0 unknown class

0 too long, 0 too short

6862 frames output, 307072 bytes

0 discards, 0 errors

0 input OLS, 0 LRR, 0 NOS, 0 loop inits

0 output OLS, 0 LRR, 0 NOS, 0 loop inits 16 receive B2B credit remaining

3 transmit B2B credit remaining.

The following example displays information for a supervisor Fibre Channel interface.

switch# show int sup-fc0 sup-fc0 is up

Hardware is FastEthernet, address is 0000.0000.0000 MTU 2596 bytes, BW 1000000 Kbit

66 packets input, 7316 bytes

Received 0 multicast frames, 0 compressed 0 input errors, 0 frame, 0 overrun 0 fifo 64 packets output, 28068 bytes, 0 underruns 0 output errors, 0 collisions, 0 fifo

0 carrier errors

	Cisco MDS 9000 Family Command Reference
78-16088-01, Cisco MDS SAN-OS Release 1.3		20-79