Cisco Systems MDS 9000 show module slot diag uptime, Specifies the slot number for the module

Chapter 20 Show Commands

show module

show module

To verify the status of a module, use the show module command.

show module [slot diag uptime]

Syntax Description

Defaults

Command Modes

Command History

Usage Guidelines

slot	Specifies the slot number for the module.
diag	Displays module-related information.
uptime	Displays the length of time that the modules have been functional in the
	switch.
None.
EXEC mode.

This command was modified in Cisco MDS SAN-OS Release 1.3(4).

If your chassis has more than one switching module, you will see the progress check if you issue the show module command several times and view the status column each time.

The switching module goes through a testing and an initializing stage before displaying an ok status.

The following table describes the possible states in which a module can exist.

show module Output	Description
powered up	The hardware has electrical power. When the hardware is powered up, the
	software begins booting.
testing	The module has established connection with the supervisor and the switching
	module is performing bootup diagnostics.
initializing	The diagnostics have passed and the configuration is being downloaded.
failure	The switch detects a switching module failure on initialization and
	automatically attempts to power-cycle the module three (3) times. After the
	third attempt it continues to display a failed state.
ok	The switch is ready to be configured.
power-denied	The switch detects insufficient power for a switching module to power up.
	In this case, issue a show environment power command to determine power
	consumption issues.
active	This module is the active supervisor module and the switch is ready to be
	configured.

	Cisco MDS 9000 Family Command Reference
20-120	78-16088-01, Cisco MDS SAN-OS Release 1.3