Cisco Systems MDS 9000 show cdp, entry, name cdp-name, global, interface, gigabitethernet, mgmt

Chapter 20 Show Commands

show cdp

show cdp

To display CDP parameters configured globally or for a specific interface, use the show cdp command.

show cdp {all entry [all name cdp-name] global interface [gigbitethernet slot/port mgmt 0] neighbors [detail interface (gigbitethernet slot/port mgmt 0 )] traffic interface [gigbitethernet slot/port mgmt 0]}

Syntax Description			all	Displays all enabled CDP interfaces.
			entry	Displays CDP database entries.
			all	Displays all CDP entries in the database
			name cdp-name	Displays CDP entries that match a specified name. Maximum length is 256
				characters.
			global	Displays global CDP parameters.
			interface	Displays CDP parameters for an interface.
			gigabitethernet	Specifies the Gigabit Ethernet interface at the slot number and port number
			slot/port	separated by a slash (/).
			mgmt 0	Specifies the Ethernet management interface.
			neighbors	Displays all CDP neighbors.
			detail	Displays detailed information for all CDP neighbors
			interface	Displays CDP information for neighbors on a specified interface.
			traffic	Displays CDP traffic statistics for an interface.
Defaults			None
Command Modes			EXEC
Command History			This command was introduced in Cisco MDS SAN-OS Release 1.1(1).
Usage Guidelines			This command is allowed only on the active supervisor module in the Cisco MDS 9500 Series.
Examples			The following example displays all CDP capable interfaces and parameters.
			switch# show cdp all
			GigabitEthernet4/1 is up
			CDP enabled on interface
			Sending CDP packets every 60 seconds
			Holdtime is 180 seconds
			GigabitEthernet4/8 is down
			CDP enabled on interface
			Sending CDP packets every 60 seconds
			Holdtime is 180 seconds
			mgmt0 is up
		Cisco MDS 9000 Family Command Reference
	20-12			78-16088-01, Cisco MDS SAN-OS Release 1.3