
FEED: MANUAL
label 1 | label 2 | |||
|
|
|
| |
|
|
|
|
|
About 21 mm |
|
| (FUNCTION IMAGE (CUT)) | |
|
| |||
|
|
Important!
∙Auto tape cut is not performed after a tape feed operation (FUNCTION and then PRINT (FEED)). In such a case, manually cut the tape as required.
∙Pressing ESC does not stop an ongoing auto tape cut operation. If you want to interrupt an ongoing auto tape cut operation, wait until the auto tape cut operation is complete and then press ESC.
Manual Tape CutPressing FUNCTION and then IMAGE (CUT) feeds the tape and then cuts it. Since the tape is fed automatically before cutting, there is no danger of figures from the previous print operation appearing at the beginning of the subsequent print operation.
You can use FUNCTION IMAGE (CUT) to manually cut the tape after interrupting a print operation by pressing ESC.
Important!
∙Tape feed is always performed with a manual cut.You cannot perform the cut operation alone.
∙FUNCTION IMAGE (CUT) does not work while a print operation is in progress, while colored tape is loaded, or when there is no tape cartridge loaded.
Affixing a Label to a SurfaceThe label printer comes with a
The following procedures describe how to use the
To remove backing paper with the built-in peeler
1. Insert the label into the peeler.
Peeler
Insert the label into the peeler until about 2mm at the end of the label bends back slightly.
Position the printed surface towards the front of the label printer.
2. Pull the label straight down through the peeler slot.
3.Repeat steps 1 and 2 until the backing paper works free from the label. You can use scissors to trim a label to the size you want.