Using Built-in Tones

Moving the Keyboard Split Point

You can use the procedure below to specify the location on the keyboard where it splits between the left side and the right side. That location is called the “split point”.

Left (Lower Range) side

 

 

Right (Upper Range) side

 

 

 

 

 

 

 

 

 

 

 

 

Split point

1. Hold down the dq (SPLIT) button until the split point setting screen appears on the display as shown below.

Current split point key name

2. Press the keyboard key where you want to specify as the leftmost key of the right (upper range) tone.

This specifies the split point.

3. Press the dq (SPLIT) button.

This exits the split point screen.

Using Octave Shift

After you split the keyboard (page E-10), you may find out that the lower range notes on the left are too low or that the upper range notes on the right are too high.

You can use octave shift to shift the octaves of the upper range and lower range upwards or downwards in octave units.

1. While holding down the cs (FUNCTION) button, press the cm (GRAND PIANO) button.

This displays the octave shift screen.

Currently selected range

Shift amount

2. Use the bt (PART) button to select the range whose octave you want to change.

•Each press of bt (PART) cycles through the ranges below.

U1 (Upper1): Main tone

U2 (Upper2): Layered tone

L1 (Lower1): Left (lower range) tone

3. Use the ct (w, q) buttons to shift the octave of the currently selected range.

•You can shift the octave within the range of –2 to 0 to 2.

4.Press the cs (FUNCTION) button.

This exits the octave shift screen.

NOTE

•Octave shift also can be performed as described for “Octave Shift” (page E-44).

English

E-11