Using Built-in Tones

Adding the Chorus Effect to the Tone

1. While holding down the cs (FUNCTION) button, press the dl (CHORUS) button.

This will display a chorus type selection screen.

2. Use the ct (w, q) buttons to select the chorus type you want.

•The following shows the five available chorus type settings.

0:OFF (no chorus)

1:Light Chorus

2:Chorus

3:Deep Chorus

4:Flanger

3.Press the cs (FUNCTION) button.

This exits the chorus type selection screen.

Using the Metronome

1. Press the 3 (METRONOME) button.

This will start the metronome.

Lights with the first beat

Lights with each

of each measure

subsequent beat of

 

each measure

2. Press the 3 (METRONOME) button again to stop the metronome.

Changing the Beats Per Measure

You can specify from two to six beats per measure for the metronome. After you do, a chime will sound at the beginning of each measure. Specifying 0 for this setting will sound a straight beat, without a chime. This setting lets you practice with a steady beat.

1. Hold down the 3 (METRONOME) button until the number of beats per measure screen shown below appears on the display.

2. Use the ct (w, q) buttons to select the beats per measure value you want.

3. Press the 3 (METRONOME) button to exit the number of beats per measure screen.

English

E-13