Casio TC-540 manual Programmable Charging, Handset LOW Battery Indicator

BOTH

PAGE

20

PROGRAMMABLE PAUSE & BATTERIES

PROGRAMMABLE	CHARGING THE
PAUSE	BATTERIES

Pause is convenient for use on a business telephone system (i.e.: PBX) when an 8 or 9 must be dialed to reach an outside phone line. This feature can also be used for a long distance service (i.e.: MCI) where you have to wait for a second dial tone before you continue dialing.

1Follow instructions on page 18 for storing autodial numbers.

2Press HOLD/PAUSE on the base unit when a pause is required. Each pause is 2 seconds in length and counts as one digit in the autodial memory.

Example: 9 PAUSE 1 2 1 3 5 5 5 1 2 1 2

	HOLD
	PAUSE
	HOLD	SCREEN
		PLAY
TALK
	LO BATT	MESSAGE
BOX 1	BOX 2	BOX 3

12ABC 3 DEF

SAVE		ERASE
4 GHI	5 JKL	6MNO
7PRS	8 TUV	9WXY
REPEAT		SKIP
*	0OPER	#
TONE
VOLUME	AUTODIAL	FLASH

Charge the cordless handset batteries for 12-15 hours before using the handset for the first time. The handset is always charging while it is in the base unit and cannot be overcharged.

1Check the AC Adapter to see that it is connected correctly.

2Place the handset in the base unit. The CHARGING INDICATOR on the base unit lights to indicate the TC-540 is charging.

CHARGING

HANDSET LOW

BATTERY INDICATOR

When the battery pack needs recharging, the

LOW BATTERY INDICATOR (LO BATT) on the handset will flash. You may also notice a reduction in the quality of your cordless handset communications. Return the cordless handset to the base unit when the LO BATT indicator is flashing.

LO BATT

NOTE: The batteries can be recharged many times, but if you get a low battery indication even after 12-15 hours of charging, you should replace the battery pack.

BATTERIES - The TC-540 is shipped with the handset battery pack installed. If it becomes necessary to remove or replace the batteries see page 32.