![](/images/new-backgrounds/1140556/14055679x1.webp)
H SETTINGS
5Install a 9 volt (9V) battery in the bottom of the base unit to protect your outgoing and incoming messages, remote code and time/day setting. (See page 32.) If a
US Patents 5,400,393 & 5,289,529; Other Patents Pending
SWITCH SETTINGS
The
POWER SAVER/RINGER
ON-OFF
The
RINGER ON - When the ringer is ON, the handset will ring when an incoming call or paging signal is received. The rechargeable batteries will last up to seven days in this mode (the Power Saver Switch is OFF.)
POWER SAVER (PWR SAVER) ON - When an incoming call or a paging signal is received the handset will not ring but, all other handset functions will operate. The rechargeable batteries will last up to 2 months in this mode (the ringer is OFF.)
RINGER VOLUME
Set the RINGER VOLUME SWITCH to control the telephone ringer volume.
HI = Loud LO = Quiet
OFF = Ringer is turned off
OFF LO HI
RING VOL
BASE
PAGE
3
RING SELECT
The answering machine is shipped with the Ring Select Switch set to 4 rings. Set the RING SELECT SWITCH to 2, 4, or TS to select the number of rings before the
TS 2 4
RINGS
2 = The
eliminate toll charges by letting you know if there are any new messages in the mailboxes before the
Second ring = NEW messages Fourth ring = NO new messages
NOTE: After you have retrieved messages, (from a remote location or at the machine) tollsaver will reset to answer on the fourth ring until a new message is recorded.
TONE/PULSE
This switch configures the
TONE PULSE
PULSE = for Rotary dialing or Pulse services TONE = for Touchtone service