Manager operation

Programming for the Australian GSTThis procedure is used for defining•Tax symbol (*) is printed.•Taxable amount (receipt) is skipped.•“GST INCLUDED” is set to the TX1 descriptor.•“TAXABLE AMT” is set to the TA1 descriptor.•Total line is printed even in direct (cash) sales.•Australian rounding is set.•“$” is set to the monetary symbol.•Print “MOF message” on receipt.

•Tax (10% tax rate, add-in tax, fraction rounding off) is set to the tax table 1. No data is set to other tax tables.

•The taxable amount and tax amount except TA1/TX1 are not printed on fixed totalizer report.

•“RND/ST” is set to the subtotal descriptor for display.•After subtotal, both “rounded ST” and “not rounded ST” are displayed.at the same time.

Procedure

MGR 601012001s6 6a (Execution)

6 s (Cancellation)

Programming of items in the program 1 mode

Use the manager control mode to program the items in the program 1 mode. These items can be preset to prohibit programming by manager control mode. The following is a list of items that you can program using the manager control mode.

•Unit prices for departments, and PLUs•Unit prices for the plus, minus, coupon keys•Second unit price for PLU•Percentage for discount/premium key•Rate or amount service charge for check cashing using the check tender key

•Rate or amount service charge for temporary finalization using the new balance key

•Date•Time•Currency exchange rate for currency exchange key•Rate tax•Scanning PLU direct maintenanceTo enter the program 1 modeX1 6 1s 6 PGM1

Mode switch

1.The register enters the program 1 mode at this point. You do not need to change the mode switch to the program position.

2.Perform program 1 programming as explained in the programming manual.To exit the program 1 mode

Change the position of the mode control key to another setting (REG1/2, RF, OFF, Z1, X2/Z2 or PGM). This procedure cancels program 1 mode of manager control (X1) mode.

154