7 Keep clicking the [OK] button on the dialog boxes that appear.
z Clicking the [OK] button in response to the “Overwrite it?” message will cause the settings of the first computer to be sent to the Data Projector. At this time, the Manual Connection 1 settings of the Data Projector will be overwritten with the “Test” settings of the connection profile of the computer (see step 3 above). The IP address setting will be the IP address of the computer’s connection profile plus 1.
8 To return to the Send Settings dialog box, click the [Cancel] button. 9 Click the [Close] button.
zThis will cause the dialog box shown below to appear.
10 On the Data Projector’s remote controller, press the [ ] key.
zThis will cause the connection profile menu to appear in the projection area.
11 Use the [T] key to move the highlighting to “Manual Connection 1” and then press the [ENTER] key.
zThis will display the dialog box shown below.
12 Presskey. the [S] key to move the highlighting to “Yes” and then press the [ENTER]
zThis will cause the message shown below to appear in the projection area.
Check to make sure that “Manual Connection 1 (Test)” is shown.
59